Capital A for Attitude FTU

Capital A for Attitude

I used the wonderful poser called Electra by Designs by Norella which you must be licensed to use. You can purchase her tubes from PicsForDesign which can now be found here

I am using a scrapkit called  Diva With an Attitude which is FTU  and can be found at Twinky Dezines here.

Font of Choice  I used Engagement

Mask of Choice I used Weescotlass WSLMask220  these masks are Here 

Plugins used were xero radiance

The tut was written in Paint Shop Pro X4 but should work in others.

Note When I resize I use these settings: (make sure that pixel dimensions is on percent and in advanced setting it is smart size lock aspect ratio is checked and resize all layers is unchecked) also please save often and for placement on the tag you can always refer to the example tag if that helps.

Let's get started!!

Open a new image 800 X 800 pixels with a transparent background.  You can resize later to meet your needs.

Copy & paste paper8 from the scrapkit onto your new image resize by 144% and apply your mask of choice. (Click layers, load save mask, make sure fit to canvas, source luminance and hide all mask is checked then click load) In layers right click on mask hit delete and answer yes to the popup. Now right click on group layer merge merge group.  

Open corset2 and copy & paste to your image and place it on the left side of your mask so that a small part of the mask shows

Open ribbonboweyelet2 copy & paste to your image resize by 79% duplicate x1  and place one on each side of the corset

Open Negativeframe2 copy & paste to your image  place it at the bottom of the mask and take your magic wand using the following settings 

and click inside of your frame expand your selections with the following setting

Open paper 4 copy and paste to your image ( make sure the paper covers the inside of your frame) and hit selections invert delete move this layer under your frame do not deselect

Open your tube of choice (I used the largest one of the face) copy & paste it to your image resize if need ( I resized 41% for the two on the ends and left full size in the middle frames) and move it so that the part of the tube you wish to keep is situated in the frame opening them hit delete go to selection select none repeat this for all four frame openings 

Open ribbon copy & paste to your image and place it in the middle of your corset

Open lips copy & paste to your image resize by 27% and place on the right side on your mask in the middle free rotate with the following settings

 Go to layers click on a layer and merge layers visible you should have this as a layer

Go to effects xero radiance and apply the following settings (if you don't have this plugin you can leave as is or play around with the others)

Open your tube of choice and copy & paste to your image resize as needed (I resized by 20%)  and place on the right side of the wordart

Add your copyrights and name of choice and you are finished!!

I hope you liked this tut and please let me know it anything is not correct. Thank you.

Be Creative as you want!